A Planned Maintenance Program is available by contract with Cummins Power Systems which includes performing the periodic inspections listed below. A written report will be provided to the customer within 10 days of the inspection.

For maintenance and service call:

Cummins Power Systems, Inc.
Tel: 410-590-8700
Fax: 410-590-8722
Glen Burnie Branch (Full Service facility)
1907 Park 100 Drive
Glen Burnie, MD 21061

1. Spark plugs, ignition contact points, and condensers to be cleaned and adjusted or replaced when necessary (gaseous fueled only)
2. Timing to be checked and set when necessary
3. Change oil and oil filters once per year.
4. Fuel tanks and lines to be inspected for the purpose of determining if excessive sludge or rust is collecting. All fuel filters and sediment bowls to be cleaned or replaced as required. Access for inspection to be provided by the customer.
5. Check entire equipment for fuel, oil, or coolant leaks.
6. Check condition of batteries and report any action necessary for recharging or replacement.
7. Clean air filter or replace as necessary.
8. Check coolant level and antifreeze protection level.
9. Check all hoses and belts for wear.
10. Check automatic transfer switch for proper operation. Operate under emergency load if conditions permit.
11. Check all instruments for proper operation.
12. Operate generator set system and conduct test (under building load when practical).